Tel: +86-373-3090228

E-mail: zhongyuefilter@sohu.com

Home > Knowledge > Content
How to do the shortage of oil and gas separator
- Jul 21, 2018 -

The filter net of oil and gas separator is too dirty, which will cause no oil supply or insufficient oil supply, vibration and noise increase, and the filter net is very easy to get dirty (especially when the oil pipe is not clean or the quality of oil is bad), so it is necessary to do a good job of cleaning. Once the fuel supply is insufficient, the filter screen should be cleaned. The steps are as follows:

1. Carry out external observation to ensure normal rotation of motor and oil pump (no reversal or no turning).

2. Remove the end cover of the filter of the oil and gas separator, remove the filter, clean the filter screen, and check the low pressure chamber of the separator. If there is no oil in the low pressure chamber, it can be judged that the oil pipe is leaking oil, the valve is not tightly closed or the oil in the tank is not oil, resulting in no oil supply.

If the motor rotates normally, there is no problem with the oil separator filter, so the oil valve should be overhauled. The oil valve can not be shut down strictly, which can cause oil and gas to be unable to separate and supply oil slowly; the oil outlet valve is stuck and can not be opened. The oil supply is insufficient, the noise and vibration increase and the exhaust pipe is injected. The solution is to unload the spring seat on the lower part of the oil valve and clean the oil valve.