Tel: +86-373-3090228

E-mail: zhongyuefilter@sohu.com

Pleated Panel Filter

The Pleated Panel Filter has the advantages of large filtration area, low initial resistance and high dust holding capacity, and is economical and practical.

Send InquiryChat Now
Product Details

Introduction

The Pleated Panel Filter has the advantages of large filtration area, low initial resistance and high dust holding capacity, and is economical and practical.

Capture particle dust and bulk debris above 10 μm.

It can capture particle dust and bulk debris above 10 μm.

 

Purpose: coarse dust filtration, air filtration system pre filtration.

Type: synthetic fiber Pleated Panel filter

Frame: aluminum, galvanized frame, paper frame

Filter material: synthetic fiber

Protection network: aluminum net or stainless steel net

EN 799 levels: G2, G3, G4, F5

Average weight efficiency: 84%-90%

EUROVENT4/5 level: EU3, EU4, EU5

DIN 53438 flame retardant standard: F1

Final resistance: (suggestion) 200Pa- (maximum) 250Pa

Maximum air volume: 125% of the rated air volume

Temperature resistance: 100℃

Humidity: 100%

 

Cleaning of Pleated Panel Filter

1. Open the inhalation grille in the equipment and press the button on both sides gently to pull down.

2. Drag the hook on the air filter to pull out the equipment below the diagonally.

3, Remove dust from a device similar to a vacuum cleaner or rinse with warm water..

4, If you encounter too much dust, you can use soft brush and neutral detergent to clean. After cleaning, dry the water and place it in a cool place to dry.

5, Do not use hot water above 50℃ for cleaning, so as to avoid the phenomenon of equipment fading or deformation, and do not dry on the fire.

6, When the cleaning is completed, be sure to install the equipment in time. When installed, the equipment is mounted on the part of the upper part of the suction grid, then fixed to the suction grid, and the rear shank of the suction grid is slid slowly until the whole equipment is pushed into the grille.

7, The last step is to close the suction grid, which is just the opposite of the first step. Holding down the filter reset button on the control disk, and the cleaning reminder sign will disappear.

8, also remind you, if the air filter used in the environment is too much dust, then the number of cleaning should be increased, usually half a year for the appropriate.



Hot Tags: pleated panel filter, China, suppliers, manufacturers, factory, customized, buy
Related Products
Inquiry