Tel: +86-373-3090228

E-mail: zhongyuefilter@sohu.com

Oil Filter Replacement for Fusheng

​Our factory produces a substitute for oil filters for Fusheng air compressors.

Send InquiryChat Now
Product Details


Spin-on oil filter:


参数-外置油滤2.jpg



Built-in oil filter

 参数-内置油滤2.jpg


The service life: 2000 hours

DSC_7064_副本.jpgDSC_6882_副本.jpg

Our factory produces a substitute for oil filters for Fusheng air compressors.

Our factory is a professional supplier of air compressor filter, providing you with the replacement air filters, oil filters oil separators for Ingersoll Rand compressors, Atlas Copco compressors, Fusheng compressors, Compare compressors, Sullair compressors, MANN, etc., if you need them, please contact us.


The oil filter numbers of part Fu Sheng air compressors are as follows.

MODEL

P/N

NEW P/N



2116020051



2116029996

SA-08


2605531440

SA-08


2116020014

SA-11


2116020016

SA-2^4

71121111-48120

2605530180/2118029540


71121111-48020

2605530160

SA-5

96103211-23600-M1

2605530830


711823E1-26A43

2605703060


711823E1-26C27

2605700980

SA-250

711823E1-2116128

2605702870


711823E1-301ETY369A

2605703170/2605702390


711823E1-301ETY369

2605702930

SA-250/375

711823E1-2118345

2605702910


711823E1-2118342


SA-250/375

711632E1-201EDM369



711632E1-201EDM369A


SA-375

711823E1-26A43

2605703060


Requirements for the installation of oil filter

1, after removing the oil filter, it is necessary to clean and install the base. The dust left between the flange and the washer will cause the new washer to deform and tear, resulting in leakage.  

2. Removing the old oil filter, please confirm that the old washer is not attached to the mounting base.

3. Before installing, please use clean oil to lubricate the washer of the oil filter.

4, do not use grease to lubricate the washer of the oil filter. The grease and the washer are incompatible and may cause oil leakage.

5, do not over tighten the oil filter. This will cause excessive pressure on the thread and washer of the oil filter, resulting in leakage. Many large filters must be fastened with wrench. Installation marks marked on the filter tank will avoid operator misoperation during fastening.

6, do not remove and reinstall the used filter. Because the washer with reduced performance may cause leakage.

7, check the filter before installation (check whether it is damaged, and whether the washer is good).

8, make sure that the product number of the filter is correct, and whether the number of the filter can be matched with the number of the outer package. Because the filter installed on the base is not always the right filter. 

9, during the installation process, the tank should be removed and replaced with dents. Dents will cause stress concentration and increase the possibility of breakage. It is important to know that the cost of replacing a filter is much lower than the cost of repair caused by filter failure.


Hot Tags: oil filter replacement for fusheng, China, suppliers, manufacturers, factory, customized, buy
Related Products
Inquiry