Tel: +86-373-3090228

E-mail: zhongyuefilter@sohu.com

Vacuum Pump Oil Separator Filter 02250048-713

The damage pressure difference of the oil filter element design is 0.5MPA, so after the compressor is boosted, the vent valve should be gradually opened until the load volume is reached.

Send InquiryChat Now
Product Details

Introduction

1. The damage pressure difference of the oil filter element design is 0.5MPA, so after the compressor is boosted, the vent valve should be gradually opened until the load volume is reached.It is strictly forbidden to empty the filter suddenly, resulting in the separation of the filter core from the layer or the flattening of the filter element, and a large amount of oil carrying.

2. Backflow or fluctuation of compressed air filter will lead to fine separation layer damage, resulting in failure of filter element.

3. Beyond the range of 20% of the design speed of oil and gas separation filter, the amount of oil carrying will increase.

4. The working life is mainly limited to the solid particles deposited in the fine separation layer. The high precision air filtration and oil filtration can be used to replace the oil on time, which can effectively prolong the working life of the oil separator.


Maintenance of vacuum pump Oil Separator

1. Use high standard vacuum pump oil. The vacuum pump oil has a decisive role on the function of the oil type rotary chip pump. It is very important, so we can not use other lubricating oil casually.

2. Replace the vacuum pump oil and oil filter regularly, if the oil is contaminated and blackened, emulsified or thickened, oil should be changed in time. While changing the oil, the oil filter should be replaced and the pump should be cleaned before adding new oil.

3. Clean the suction screen, keep it clean, so as to avoid pumping speed down.

4. Replace the Oil Separator.If the pump temperature rises obviously, the motor current reaches or exceeds the rated current, the exhaust port of the pump is produced by the fume, then the exhaust filter should be checked to be blocked. If the blockage appears, the replacement should be made in time. An exhaust pressure gauge can be installed at the pump fuel hole to check whether the filter is clogged. When the pressure exceeds 0.6bar (table pressure), replace the exhaust filter.


Hot Tags: vacuum pump oil separator filter 02250048-713, China, suppliers, manufacturers, factory, customized, buy
Related Products
Inquiry